A technologically advanced and reliable hardware platform is the foundation of the company’s product quality. The maintenance of hardware circuit board can analyze and summarize the causes of fault points and improve them in a targeted manner, which is of great significance.
1. Basic qualities and skills of maintenance personnel
Maintenance personnel should master the following basic skills:
1) Identification, detection, selection, and replacement of basic components;
2) Manual soldering technology of electronic components;
3) Basic application of circuit board design software (such as Altium Designer), such as opening, closing, shifting left and right, zooming in and out, etc.;
4) The ability to find device information on the Internet;
If you feel that you still don’t have enough mastery of the above technology, you can learn online. There are many learning platforms on the Internet now, with videos and learning materials. Manual soldering technology should be practiced more to reach the level of being able to remove and solder devices with more than 48 pins without soldering. Device information can be found on websites such as https://www.alldatasheetcn.com/ or Jiali Chuang Electronic Mall. As long as you enter the device model, there is generally corresponding information.
2. Repair process
1) Clean the circuit board
This step is very important. The circuit board must be cleaned before repair. The purpose of doing this is: first, it is easy to find the problem point, and second, it looks comfortable after the repair and the customer is satisfied.

2) Check the instructions for the fault point attached to the circuit board
With this instruction, the cause of the fault can be found faster, so when communicating with after-sales and customers, remind them that the circuit board returned to the factory must indicate the fault phenomenon.
3) Measure the voltage point
After the first two steps, we will now start to find the fault point. First, we must power the circuit board, right? At this time, we must consider whether the power supply on the circuit board will be short-circuited, so first put the multimeter pen on the main power supply, and disconnect the power supply immediately after plugging in and finding no voltage. If the main power supply is normal, measure other voltage points. If the voltage point is abnormal, repair the voltage regulator circuit first. Commonly used voltage regulator circuits include linear voltage regulator circuits such as LM7805 or LM1117-3.3V, and switching voltage regulator circuits such as TPS5430, etc. If you are not familiar with these chips, you can check the information on the Internet. Generally, there will be recommended circuit principles.

4) Check each functional module
After the voltage is normal, check whether each functional module on the circuit board is normal. For the gas station, the commonly used functional modules are the display board driver module, keyboard driver module, sensor input module, sensor detection module, gun switch input module, RS485 communication module, counter output module, storage module, power-off re-display module, power-off detection module, motor and electric valve driver module, etc. First, repair the faulty module. After troubleshooting, other modules also need to be tested to ensure that the circuit board functions normally. To be familiar with the above functional modules, you can use software such as Altium Designer, open the circuit board schematic, and master one module at a time. If you are not sure, you can go online to check the reference circuit of similar chips.

5) Keep a good maintenance record
After the circuit board is repaired, you must keep a record, including the fault phenomenon, damaged devices, etc. The data can be slowly accumulated to analyze which part of the circuit board or which component is easily damaged, and then feedback to the development department for upgrade and improvement to improve product quality.
The above is my process and experience when repairing the circuit board. I hope it will be helpful to everyone.