Gas Alarm User Manual

While everyone knows how to detect gas leaks, specialized detection is no longer necessary thanks to gas alarm systems. Let’s look at how to use a gas alarm.

Gas detector

1. Power On

Connect the detector to the controller device you want to control, ensuring there are no hardware connection errors. Then, turn on the detector. It should display the gas type, range, alarm value, and numbers, indicating the start of detection. Combustible gas detectors require a 60-second warm-up.

2. Detection

When the gas concentration is higher than the set concentration, the alarm will sound, and the LED will flash. Press the mute button on the remote control to silence the sound. When the gas concentration is lower than the set concentration, the alarm will stop sounding, and the LED will turn off.

3. Settings

  • Low/High Alarm: Set the detector’s alarm point.
  • Zeroing: The detector automatically adjusts to zero. Zeroing must be done in clean air.
  • Calibration: Use a standard gas to purge the detector and adjust the standard value to calibrate it. Do not modify without standard gas.
  • Address: Modify the 485 communication address code.
  • Function: Correct the 4-20mA output current.

Basic Controller Operation:

 Power On:

Connect cables, main power, and external devices. The controller will enter a delay waiting state. Toxic gas controllers will sequentially display the range, high alarm, and low alarm. Combustible gas controllers will have a 60-second preheating time for the sensor to prevent false alarms. After the delay, the controller will enter normal monitoring mode. The controller can set two independent alarm points for each channel. The alarm point setting range is 5%-90% of the full range. The buzzer frequency during an alarm is higher for a high alarm than for a low alarm.

Alarm Setting:

Press the (Set) button. The digital display will show “L-XX” flashing, indicating that the low-level alarm is in the setting. Press the Set button again. The digital display will show “H-XX” flashing, indicating that the high-level alarm is in the setting state. Press the Set button again to exit the setting process.

Update cookies preferences
WhatsApp

Get a Quick Quote!

x

    Get a Quick Quote!

    x