What if the fuel dispenser is running idle?

Within the category of special equipment, fuel dispensers are subject to strict regulatory oversight from production to routine maintenance. We’d like to share a story about some customers experiencing their fuel dispensers running idle when they lift the nozzle. Ten years ago, a common cheating method at gas stations was to run the nozzle idle, causing charges to be incurred before fuel was even added to the tank. Today, we’ll explain what exactly happened.What to do if the fuel dispenser is running idle when you pick up the nozzle?

Avoid leaving the fuel dispenser empty after lifting the nozzle.

Daily precautions:

1. The longer the hose, the greater its internal expandable volume. In daily use, do not arbitrarily lengthen the hose.

Check the fuel dispenser

2.Do not pull or yank the hose forcefully during daily use to prevent damage to the sealing rings at both ends of the return air hose, which could lead to a connection between the oil and air circuits and cause the hose to run out of power.

3.After use, the hose should be stowed away and placed on the hose hook. This is to prevent damage to the inner air return hose from being run over by vehicles.

Inspect the internal pipes of the fuel dispenser

4.Maintain pressure balance within the oil tank and regularly check the breather valve’s performance to prevent excessive negative pressure from causing backflow of oil.

5.Regularly replace the seals at both ends of the gas line, using genuine parts with reliable quality assurance.

Regularly replace the seals at both ends of the gas line

Maintenance Measures:

1. If the flow rate is constant, stop the generator and inspect the bottom valve. After ensuring proper safety and explosion-proof measures are in place, remove the bottom valve from the oil tank and test its sealing performance and switching flexibility by applying appropriate pressure.

2. If continuous flow is observed, assuming the self-priming pump pipeline is not damaged, check for oil backflow by stopping the oil vapor recovery vacuum pump or opening one end of the vacuum pump’s outlet. If oil backflow is detected, perform an O-tight seal test by opening sections of the oil gun and hose, hose and disconnect valve, and hose and oil-gas separator connector. Ensure proper safety and explosion-proof measures are in place throughout the entire maintenance process.

The above five points are things to pay attention to in daily life.

Update cookies preferences
WhatsApp

Get a Quick Quote!

x

    Get a Quick Quote!

    x